Just after the groups collective opinion on the suitability of a fluke 332d as a voltage standard for a home lab. --- This email is free from viruses and malware because avast! Antivirus protection is active. http://www.avast.com

Ken, I think the 332D would be a good tool for calibration of DMM's, etc., but probably a bit of an energy hog to leave turned on all the time. What do you want to do? For a constantly on 10 VDC reference, I would consider a 731B or 732A. For a 'calibrator', the 332D would be a good DC voltage calibrator up to 1100 VDC, IIRC. If you also need AC voltage, current, and resistance, consider a Fluke 5100B. For separate units, consider a 5200 for AC voltage and 5450 or some individual standard resistors for resistance. If you want only DC voltage and more stability than the 332D, consider a 5440B. Careful, this stuff can be addicting. Good luck. Joe -----Original Message----- From: volt-nuts-bounces@febo.com [mailto:volt-nuts-bounces@febo.com] On Behalf Of Ken Goodhew Sent: Sunday, March 09, 2014 8:06 PM To: volt-nuts@febo.com Subject: [volt-nuts] fluke 332d Just after the groups collective opinion on the suitability of a fluke 332d as a voltage standard for a home lab. --- This email is free from viruses and malware because avast! Antivirus protection is active. http://www.avast.com _______________________________________________ volt-nuts mailing list -- volt-nuts@febo.com To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/volt-nuts and follow the instructions there.