Jeremy, No, Allerta Stencil will not work. It appears that every character has a bridge. Characters such as W, C, E, etc, do not need a bridge. On Sun, Mar 26, 2023 at 4:17 PM jeremy ardley via Discuss < discuss@lists.openscad.org> wrote: > > > > ---------- Forwarded message ---------- > From: jeremy ardley <jeremy@ardley.org> > To: discuss@lists.openscad.org > Cc: > Bcc: > Date: Mon, 27 Mar 2023 05:16:02 +0800 > Subject: [OpenSCAD] Re: Stencil Font with Minimal Bridging > > > On 27/3/23 04:53, larry wrote: > > > So far, I have only located one, but it's not free. > <https://www.myfonts.com/collections/stencil-allround-font-letterwerk> <https://www.myfonts.com/collections/stencil-allround-font-letterwerk> > > I think there's real need for such a font. If I needed one, I would > probably use a font editor that has the ability to modify an existing > font. > > I'm going to check out FontForge.<https://github.com/fontforge/fontforge> <https://github.com/fontforge/fontforge> > _______________________________________________ > OpenSCAD mailing list > To unsubscribe send an email to discuss-leave@lists.openscad.org > > There is a free font https://fonts.google.com/specimen/Allerta+Stencil > > -- > > Jeremy > > > > ---------- Forwarded message ---------- > From: jeremy ardley via Discuss <discuss@lists.openscad.org> > To: discuss@lists.openscad.org > Cc: jeremy ardley <jeremy@ardley.org> > Bcc: > Date: Mon, 27 Mar 2023 05:16:02 +0800 > Subject: [OpenSCAD] Re: Stencil Font with Minimal Bridging > _______________________________________________ > OpenSCAD mailing list > To unsubscribe send an email to discuss-leave@lists.openscad.org >