Putting up for adoption is our 26 outer reef trawler built in 1979 in Palmetto FL. She is 26 ft long with a 9 ft beam, weighs around 10,000 lbs, she is powered by a 40hp Isuzu diesel that was rebuilt when we bought her and had 22 hours on the engine at that time, She now has 665 as of Sunday when we had her out. The hull was sandblasted from the caprail to the keel and sealed and primed and painted with 1 coat of 2 part sealer and 3 coats of primer and 2 coats of bottom paint last October and 1 coat of sealer and 3 coats of primer and 5 coats of Awlgrip on the hullsides, we sanded the entire deck and house and Awlgriped the deck and the house from the caprail to the top of the fake smoke stack which is storage, by the way. We had new white window covers made for ALL of the windows and hatches about a year ago. She has a propane stove, refrigerator, a 6 gallon electric hot water heater with a heat exchanger and a 12,000 btu marine air air conditioning unit installed but not fully plumbed yet. The air conditioning works great but the vents are not installed. I installed an aft cockpit hot/cold shower 2 years ago and it works great, ( just used on sunday ) There is a head with a warm water shower, a 5 gallon blackwater tank with deck pumpout or overboard discharge, a 53 gallon freshwater tank and 2 60 gallon fuel tanks, please be aware 1 of the fuel tanks has a leak so really 60 gallon fuel capacity at this time. She burns 1 gallon per hour at a 6.5 knot cruise and a 7.0 to 10 knot wot depending on which way the tide is flowing I replaced all of the freshwater plumbing with Whale Products so everything is quick disconnect, there is a Norcold ac/dc refrigerator that works fantastic ( this weekend), a princess propane stove that works great underway or when you make port. All new carpet in January of this year, The bottom was painted with interlux and the prop and rudder covered with propspeed last fall and is in great condition as of this past weekend, we replaced the prop shaft, coupler, cutlass bearing and had a custom made stainless rudder built when we bought her in 2003 and the cutlass bearing was replaced this last October at Apex Marine in Ft. Lauderdale along with all fluids in the engine and transmission. She has 30ft of polished stainless chain and a 30lb polished stainless anchor for ground tackle, no windlass and tons of spare parts to keep you safe. She has a Garmin GPS Map 198-C Sounder that works great. No autopilot. Please call 239-784-6211 for more information and pictures, we are asking $24,900 Thanks for your consideration Bob