Hi Pete Thanks for your comment, I have considered stripping it for parts and might still do so if there's no takers, but it's in such nice condition that I've been very reluctant to do that, which is probably one of the main reasons I'm crowded out by old test gear and radio kit that I'll never find time to use again:-) Regards Nigel GM8PZR In a message dated 07/08/2015 05:17:45 GMT Daylight Time, pete@petelancashire.com writes: A great source of parts for DIY volt-nut projects On Thu, Aug 6, 2015 at 3:43 PM, Nigel Clarke via volt-nuts < volt-nuts@febo.com> wrote: > I have a Fluke 760A calibrator, complete with original manual including > schematics etc, that I haven't powered up for a few years but as best I > remember was working last time I tried it. > > This is available free of charge to anyone willing and able to collect from > the west coast of Scotland. > > It's far too heavy to ship and should be accepted as is, I won't be testing > it again as I don't have time to get distracted chasing any problems that > might arise. > > Regards > > Nigel > GM8PZR > _______________________________________________ > volt-nuts mailing list -- volt-nuts@febo.com > To unsubscribe, go to > https://www.febo.com/cgi-bin/mailman/listinfo/volt-nuts > and follow the instructions there. > _______________________________________________ volt-nuts mailing list -- volt-nuts@febo.com To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/volt-nuts and follow the instructions there.