Does anyone know where I can find the AC option 10/12 board for the Datron 1271. Is it as simple as plugging it in or do you need a matched version with hardware version?

Greg Welby
(905) 891-0050

www.NetworkingGurus.comhttp://www.NetworkingGurus.com
[Signature]

I have one spare (Germany).
The AC option is a board with shields and cables. Simple to plug-in and to mount at the bottom of the system.
Same as for the current option board.
The 1271/81 detects it when the function is activated.
There is no special requirement or matched version, but for sure you need to calibrate it.

BR
PeLuLe
 
 

Gesendet: Mittwoch, 10. Juni 2015 um 17:38 Uhr
Von: "Greg Welby" Greg@NetworkingGurus.com
An: "volt-nuts@febo.com" volt-nuts@febo.com
Betreff: [volt-nuts] Datron 1271 AC Option
Does anyone know where I can find the AC option 10/12 board for the Datron 1271. Is it as simple as plugging it in or do you need a matched version with hardware version?

Greg Welby
(905) 891-0050

www.NetworkingGurus.com[http://www.NetworkingGurus.com]http://www.NetworkingGurus.com[http://www.NetworkingGurus.com]
[Signature]

volt-nuts mailing list -- volt-nuts@febo.com
To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/volt-nuts[https://www.febo.com/cgi-bin/mailman/listinfo/volt-nuts]
and follow the instructions there.

you just plug it in and apply the calibration. only the current option requires a jumper on the conversion board otherwise you get an error message about a fuse.you need to find a unit behind repair with good options.
 Regards

Frans

http://ElectronicsAndBooks.com

Discere ne cesses