Does anyone have any information about the Fluke 735C 10.00000 DC Voltage Standard? Thanks. Joe

735C = prototype version of the 732A. 10V output only, no 1V divider. As far as I know it was used for DC transfer experiments from the Fluke primary lab to their other calibration sites. 2013/9/7, J. L. Trantham <jltran@att.net>: > Does anyone have any information about the Fluke 735C 10.00000 DC Voltage > Standard? > > > > Thanks. > > > > Joe > > _______________________________________________ > volt-nuts mailing list -- volt-nuts@febo.com > To unsubscribe, go to > https://www.febo.com/cgi-bin/mailman/listinfo/volt-nuts > and follow the instructions there. >

Will, Thanks for the info. I'll download the 732A manual and see how it compares. It is quite 'the beast'. I plugged it in, connected it to my (recently Fluke calibrated) Fluke 8846A and it read 10.00000 VDC. This AM it read 10.00007 VDC The 'TH' resistance read about 8000 ohms (IIRC) and slowly came down as the unit 'warmed up'. This AM it is about 3330 ohms. I'd love to know what the 'normal value' of this is at operating temperature. I need to replace the NiCd's and 'clean up' some corrosion on the battery charger board but it looks like it will be an interesting addition. It has a 'sticker' relating calibration in 1982 by 'Primary Standards Lab' with a 're-cal' date 3 months later. So, that would fit as a 'transfer standard'. I'll have to get it 'back in shape', allow it to stabilize for a couple of weeks then see what it is on my 3458A. Do you have any 'specifications' or other documents about it? Thanks again. Joe -----Original Message----- From: volt-nuts-bounces@febo.com [mailto:volt-nuts-bounces@febo.com] On Behalf Of Will Sent: Saturday, September 07, 2013 7:57 AM To: Discussion of precise voltage measurement Subject: Re: [volt-nuts] Fluke 735C - Information Needed 735C = prototype version of the 732A. 10V output only, no 1V divider. As far as I know it was used for DC transfer experiments from the Fluke primary lab to their other calibration sites. 2013/9/7, J. L. Trantham <jltran@att.net>: > Does anyone have any information about the Fluke 735C 10.00000 DC > Voltage Standard? > > > > Thanks. > > > > Joe > > _______________________________________________ > volt-nuts mailing list -- volt-nuts@febo.com To unsubscribe, go to > https://www.febo.com/cgi-bin/mailman/listinfo/volt-nuts > and follow the instructions there. > _______________________________________________ volt-nuts mailing list -- volt-nuts@febo.com To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/volt-nuts and follow the instructions there.