Hi all, I am new on this list, even if I have been reading now and then.... I am thinking of buying a used NI PXI-4071 7.5 digit DMM module. What do you think is a reasonable cost to have it calibrated in the US before being shipped to me in Europe? A ballpark price is fine. Any particular lab you recommend? Thanks in advance Jan

Hi Jan, I've been following for a while and haven't been involved yet but this question was up my alley since I used to work on the DMMs while I was at NI. You can get the cal done through NI at (includes pricing info) http://sine.ni.com/nips/cds/view/p/lang/en/nid/207959 They use a few different cal labs depending on the level of service and region. There are some links below from this page including the descriptions of the service levels as well as the cal labs that are used off of this page: http://www.ni.com/services/calibration Hopefully this is a good starting point. Steve On Thu, Aug 1, 2013 at 2:46 AM, Jan Fredriksson <jan@41hz.com> wrote: > Hi all, > > I am new on this list, even if I have been reading now and then.... > > I am thinking of buying a used NI PXI-4071 7.5 digit DMM module. > > What do you think is a reasonable cost to have it calibrated in the US > before being shipped to me in Europe? A ballpark price is fine. Any > particular lab you recommend? > > Thanks in advance > > Jan > _______________________________________________ > volt-nuts mailing list -- volt-nuts@febo.com > To unsubscribe, go to > https://www.febo.com/cgi-bin/mailman/listinfo/volt-nuts > and follow the instructions there. >