Peter, Thanks, that doc has the procedure in it. It is the long term drift correction procedure. It wasn't a long shot after all. Much appreciated. Steve Grady -----Original Message----- From: xyzzypdx@gmail.com [mailto:xyzzypdx@gmail.com] On Behalf Of Pete Lancashire Sent: Friday, 19 August 2011 5:07 AM To: grady.steve@gmail.com Subject: Re: [volt-nuts] Adjustment of Fluke 752A Reference Divider Long shot .. https://docs.google.com/viewer?a=v&pid=explorer&chrome=true&srcid=0B86wM5n5R E3kMjRjMjUyYzEtMjU3My00Nzg0LTg2N2QtNjljM2VjYjczMjUx&hl=en_US On Thu, Aug 18, 2011 at 11:56 AM, Stephen Grady <grady.steve@gmail.com> wrote: > Fellow Volt-nuts, > > > > I have a couple of Fluke 752A Reference Dividers at work that the front > panel adjustments of the Hammond Divider are outside of its adjust range > (that is the will not adjust into balance). I remember at my previous > laboratory the Fluke manual described a procedure to adjust the divider back > into its adjustment range by soldering (or unsoldering some links in the > divider circuitry. The present Fluke manual that is downloadable from > Fluke's website no longer has this section in the manual and asks that the > divider be returned to Fluke for repair. Does anyone have access to a pdf > version of the old manual or just this section of the manual that they can > email me, post online or provide a link? It would be much appreciated. > > > > I would really like to get these dividers working again. > > > > Thanks, > > > > > > Steve Grady > > grady.steve at gmail.com > > Sydney Australia > > > > > > _______________________________________________ > volt-nuts mailing list -- volt-nuts@febo.com > To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/volt-nuts > and follow the instructions there. >